USE
The BRIO TOP pressure regulator allows you to automate the starting and stopping of a single phase pump.
This device controls pressure decrease (tap opening) and interruption of flow in the system (tap closing) in the system on which the pump has been installed.
- Digital indication of pressure on the display.
- Operation/error status signalling via LEDs and on-screen.
- Automatic reset and protection against dry running in event of water shortage at suction.
- Overcurrent protection for motor (overload or locked rotor).
- Anti-freeze protection which starts the pump when the temperature falls below 4°C .
- Rotor anti-blocking function used to prevent seizure of mechanical parts during prolonged periods of pump inactivity.
- Overpressure protection (set threshold).
- Pressure set-point for operation can be set during installation phase via the digital display.
- Alarm log for simple analysis of any system malfunctions.
Supplied pre-cabled with: 1.50 m long cable with molded male plug and 0.60 m long socket for connection to motor.
Conditions of use :
- Voltage 115-230 V 50/60 Hz - 16 A.
- Setting range: 0,5 to 8 bar.
- Max. temperature: 55°C.
- Max. pressure 10 bar.
- Protection: IP 65.
- Piloting of two pumps is possible.
- TOP Brio is to be used with installations where the water passage is sediment free. If not the case, you must install a filter at input.
Standard 1" M hydraulic connections.
- Terminals for remote connection (1 input + 1 output).
- Removable electrical terminals to facilitate wiring.
- 2002/95/CE.
- TUV certified.
- In conformity with current EEC Directives.