Tel. : +33 556 899 207
Total exc. VAT
Total inc.  VAT

Our Products

Single phase / Three phase
VIGILEC Tri type

ORDER
0,00 €
0,00 €
 

USE

The VIGILEC Tri is a single control and protection unit for all single or three phase pumps.
Power supply :single phase MONO 230V and three phase 230/400V.
Protection against connection faults and selection of of voltage. Protection against phase failure.
3 modes of level control available:
  • 2 Electrodes : Min. and max. level.
  • 1 Electrode : Min. level and reset after fixed delay of 15 min. (Shunt terminals 1 and 2)
  • Without electrode : water shortage detected by under-consumption of the motor, reset after delay of 15 min. (Shunter terminals 2 and Earth).

Potentiometers for thermal protection against OVER-CURRENTS (alarm goes off within 7 s,) and UNDER-CURRENTS (alarm goes off within 3 s.) adjustable from 0 to 13 A.

Conditions of use :
  • Power supply voltage : 230 Vac (can be selected) 50/60 Hz.
  • Voltage tolerance : ± 20% Self-disconnection from +30%.
  • Max. current: 12 A AC3 V1N - 16 A AC3 V1E - 23 A AC3 V1F
  • Over-current setting: 0-13 A / 0-16 / 0-23 (adjustable).
  • Under-current setting: 0-13 A / 0-16 / 0-23 (adjustable).
  • Voltage at electrodes : 24 Vac.
  • Sensitivity at electrodes : Set at 9 Kohm.
  • Remote control connection: dry contact or 6 to 400 VAC/VCC.
  • Protection level: IP 56.
  • Operating temp.: -10 +55°C.
  • Remote control by dry contact or by single voltage power from 12 to 400 Vac/Vdc.
Automatic start up of the motor for 1 s. every 24 hrs. To avoid pump seizure during a long period of inactivity (in AUT position only).
Alarm in the event of excessive start-ups.
Fault report by dry contact against successive start-ups (2A max.).
Choice of AUT-O-MAN functions (quick) with embossed keys.
Reset button for pump fault (RESET).
Indicator lights for POWER ON, ON, WATER SHORTAGE and MOTOR FAULT.

Remote control by dry contact or by single voltage power from 6 to 400 Vac/Vdc.
Low voltage power supply ( < 24V) of external controls for increased security.
Cable glands with big clamping diameter and highly water-tight.
Max. cross section at terminal: 4 mm2.
Network connection : Direct by fuse holders.
Motor connection : Direct by electric switch: 4 mm2.
Wall mounted with 4 brackets and screws (supplied).
Poids : 1,5 Kg.

Download the operating instructions for V1M V1N control units
Related Products